You can now proceed to configure OpenWrt to your liking, add further partitions to the disk and install additional packages. Like with other single-port OpenWrt devices, the ethernet port will by default be assigned to the LAN interface with static IP 192.168.1.1 and serving DHCP. If you choose the wrong device, you may accidentally overwrite your system disk or another disk you may care about, so double and triple check to make sure you are writing to the correct disk. You will lose all existing data on the target disk. Warning: This overwrites the target disk with a new MBR (master boot record) and a new partition table. Replace /dev/sdx with the actual device the MBL disk is attached to. This usually requires root privileges on your system. Write this image file to the MBL disk using img.gz file to receive the image file ending in. ![]() Remove the disk from its enclosure (the right handside “Drive B” disk on MBL Duo) and connect it to a host computer running Linux, probably and most conveniently using a SATA-to-USB adapter. Beginning in 19.07 there is only one firmware image that works with both Single and Duo variants.) (Note: Up to OpenWrt 18.06, firmware images existed in two flavors, duo for the Duo and “not-duo” for the Single. Use the factory image for an initial installation, the sysupgrade image is intended for updates. ![]() Download the OpenWrt firmware image to your host computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |